Manchester Woodworks

Staircase Stairs Stock 1/12 scale steps dollhouse trim supplies 24"long 2 pcs

Staircase Stairs Stock 1/12 scale steps dollhouse trim supplies 24"long 2 pcs
Staircase Stairs Stock 1/12 scale steps dollhouse trim supplies 24"long 2 pcs
Product Code: 192400087691
Availability: In Stock

Price: $6.75

Staircase Stock

1:12 scale

Made by Manchester Dollhouse and Woodworks

Replace your plywood steps with this beautiful solid staircase stock.

For Instructions read below.


  • Two pieces measuring 11/16"thick x 1-7/16 wide x 24" long.
  • It has a 1/8" bullnose nose detail.
  • Made of unfinished basswood.
  • We made this to replace the plywood steps in a Linfield Dollhouse.
  • You cut each step to width and glue together.
  • See instructions below.

 Instructions for Making Dollhouse Wooden Stairs


Tools and materials needed:

  1. Staircase stock
  2. Saw (miter box)
  3. Wood glue
  4. Wax paper
  5. Ruler
  6. Wet cloth to wipe up excess glue.




1.      Measure the vertical height from floor to floor.  Each step is a little over 13/16” (.83”) high.

 Divide the total height by 13/16” or .83 and you will have the number of steps needed. 

If math is not your strong point, use;

·        11 steps for an 8-1/2” ceiling height

·        12 steps for a 9-1/4” ceiling height.

·        13 steps for a 10-1/8” ceiling height.


2.      Cut each step to the desired length. Use a stop block (a wood block you can butt the end of the 

staircase stock to to keep it from moving) on your miter box for repeat cuts.

3.      Sand the riser and tread of each step.

4.      Clamp a stop block to your work surface and lay out a sheet of wax paper.

5.      If you plan to use balusters and a hand rail this is the time to drill the holes

 in each step. (But don't glue the balusters in place yet.)

6.   Add a bead of glue to each surface and press each piece together flat on its 

back. Glue on top of  wax paper to keep glue off your work surface. Butt the 

pieces up to a stop block to help hold them in place.

7.   After the glue is set, sand the edges and back. Be careful not to drop or 

bend the stairs. If it breaks, reglue it.

8.   Measure and cut the stair supports to length and glue to the underside of 

the stair.  This is not necessary, but it adds strength to the stairs.

9.      Set the stairs in place and mark where to cut the top step in order to glue 

it to the upper floor.

10.  Cut the top step, sand the stairs, install the newel post, handrail and balusters 

if you wish.

11.  Finish and glue the staircase in place.


·        The photo shows a rounded first step

·        If you experiment, you may create a spiral staircase

        from this stock.


For more photos check out





                                          Check out my other items!


Also check out our miniature cove and crown molding, window trim, chair rail, ridge caps, dentil crown molding, veneer flooring, corbels, window shades, hand-made art cards and baseboard at our Ebay store.


Thanks for looking


Ebay Item Specifics
Brand Manchester Wood Works
Material Wood
Scale 1:12
UPC Does not apply

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

Related Products (10)